Edgar

Ask a question

since

Wednesday

Cultivating a Following

Total posts 35
Total likes 12
Joined 27 January 2024

My latest posts
Posts I liked
My liked posts

Cultivating a Following

1 reply

I guess it is possible. It feels like around 15mm in some parts. I did a trial with an "easy drive hammer in anchor". It was pretty awkward because o ...

Cultivating a Following

3 replies

Ok. Thank you. I have tried drilling into different sections.and.i am.getting more of a bite in some areas, but the brick.seems.to be quite deep into ...

Cultivating a Following

5 replies

I'm drilling into the wall and I am struggling to find brick. It's an internal wall on a double brick flat. It seems to be hitting mortar only. What a ...

Cultivating a Following

7 replies

Thanks again Mitchell. I have purchased bracket stays and one side is longer than the other. Does the longer side run down the wall?

Cultivating a Following

Thank you so much.

Cultivating a Following

10 replies

I.want to install this benchtop piece (1600mm x 400mm) as a breakfast bar. I would like advice regarding my.options for installation. The wall it is ...

Cultivating a Following

1 reply

I'm planning on use Davco Rejuvenation Grout on my shower. Is it also suitable for the tiles that run around the bathroom floor? Can I use it to fresh ...

Cultivating a Following

1 reply

Hi Mitchell. Thank you. I have applied the oil based precision sealer binder. However, where it has contacted the pre-existing paint, that pain ...

Bunnings Team Member

2 replies

Hi @Edgar, Would you like to reinstate the glass sliding doors? If so, you'd likely need to create a timber sliding track for the glass to run in, a ...

Cultivating a Following

2 replies

Thank you! Do you have any product suggestions or guidance in how to best re-render the wall? thanks again

Cultivating a Following

5 replies

I have removed the old vanity from the bathroom of my double brick flat. The photos shows the result. The replacement vanity will mostly cover the sam ...

Cultivating a Following

Thank you very much.

Cultivating a Following

I practiced on another offcut today and all your tips were very, very helpful and I successfully made a cutout in one of my offcuts. It wasn't perfect ...

Cultivating a Following

Wow! That was quick. Thank you for the suggestion. I think that could be a good workaround. When I can I'll post some more photos, as I have a couple ...

Cultivating a Following

6 replies

All the door frames in our 1960's apartment are metal. I recently removed some shelving which was anchored on to one of these door frames and it obvio ...

Cultivating a Following

Thank you. That is very helpful.

Cultivating a Following

8 replies

Thank you very much. I need to purchase a circular saw and also a jigsaw (for the sink cut out). Any recommendations? Things to look out for?

Edgar's Bookmarks

Go to Bunnings

Online Status	Offline
Date Last Visited	Wednesday

Re: installing breakfast bar

Re: installing breakfast bar

Re: installing breakfast bar

Re: installing breakfast bar

Re: installing breakfast bar

How to install breakfast bar?

How to refresh shower tile grout?

Re: new plaster wall

Re: reinstating the shavers cabinet

Re: How to repair and resurface wall behind vanity?

How to repair and resurface wall behind vanity?

Re: How to seal brick wall in kitchen?

Re: How to installing Kaboodle Hevea benchtops?

Re: How to installing Kaboodle Hevea benchtops?

How to fill holes in metal door frame?

Re: trestle table or workbench?

Re: trestle table or workbench?

User's latest posts

Posts user liked

User's liked posts