Hi @EricL - Thanks for your response. I dont have any opening at the end of U channel. So, will have to stop the rainwater getting into it. I checke ...
I have this garden shed done by previous owners. As you can see, there are gaps where the panels meets the base and water gets through the gap inside ...
Hi there, I accidentally cracked this underground storm water drain pipe while cutting trench. Is there a way I can repair/fix it without digging out ...
I noticed this rotten wood at the fiasco, probably caused by the gutter leakage. How can I fix the rotten wood as well as fix the leakage?
Any help ...
Hi,
I am looking for a replacement for this security door (sliding) wheel. I can't remove the whole assembly as it is fitted to the bottom of the d ...
Hi @EricL, It was MDS5 and neither holes were in the correct place nor the bristles were in the correct length. I almost attempted to drill new holes ...
Hi Mitchell, Thanks for your response. Unfortunately, I can't find the brand name printed anywhere on the door. This door must be at least 15-20 year ...
Hi there,
I am trying to replace these door brushes for my security door (sliding) (pic1), but I couldn't find any compatible size to replace with? ...
Hi @bh039
Just use roof and gutter clear silicone. It's cheap and effective. It's what I used and it works a treat. I also lifted the shed walls wi ...
Hi @bh039, Thank you for your question. You will have to dig out enough width to see the full extent of the damage plus around 20cm on each side so th ...
Hi @bh039,
The hole assembly appears to be pop-riveted into the bottom of the door. You'd need to take a 3mm drill, place it in the middle of the tw ...
Hello @bh039
Thank you for posting the photos of your old and new seal together. If you wish to trim the brush on the MDS5, I suggest using an alum ...
Hi @EricL, It was MDS5 and neither holes were in the correct place nor the bristles were in the correct length. I almost attempted to drill new holes ...
