Workshop
Ask a question

The Bunnings Workshop community can help with your home improvement projects.

Bathroom and Laundry

Help for bathroom and laundry renovation projects
PumpkinDIY
Community Newcomer
1 reply

Hi, I'm attempting to remove an old shower arm and replace it with a dual shower head/hose combination and have run into a couple bumps. Has anyone h ...

Wobbly74
Community Newcomer
5 replies

Hi - I have a shower drain that has failed. The waterproofing failed and the yellow tongue substrate below the tiling rotted out to the point that som ...

izozo
Community Newcomer
1 reply

Hey, does anyone know how to remove this stubborn plastic cog? It's a shower tap from the 60s I think so it's kinda old. It might need some oil/lubric ...

gloved
Just Starting Out
5 replies

    Hi, l needed to replace the above seal and bolt, due to the rubber seal being squished. Now, l can not got the seat back on the toiler. I can no ...

zaheerdalal
Finding My Feet
4 replies

Hello everyone, I am having some trouble removing the basin waste in my bathroom sink. I can remove all the plastic pipes under the sink, but after th ...

fenmilkoa
Finding My Feet
1 reply

Hello, hoping for some advicd. You can see our old shower setup and the current plumbing configuration in the attached photos. What type of shower ...

sumleung33
Just Starting Out
2 replies

Good morning, the self stick   shower head holder dropped off after being used for a few months. I've tried to put it back, but it dropped off again ...

handyroo
Just Starting Out
3 replies

 want to know where a second toilet could be put? Bedroom 2 or the laundry?

mikel1
Just Starting Out
2 replies

I am in the middle of a full bathroom renovation and have fitted a shower/bath (not finished, plastic protective wrapper is still on the bath). The dr ...

FreddyG
Just Starting Out
2 replies

Hi guys. My front load washer doesn’t require hot water connection. The hot water tap on the wall is obstructing where I’d like to position the washin ...

robyn1
Just Starting Out
11 replies

Help. The instructions are missing. How do I reduce the height shaft to fit in the toilet. This is a very urgent problem. It looks like it needs to ...

billy59
Just Starting Out
1 reply

hello, got a leaking cistern in mbi toilet. Is it better to replace original parts or replace with a new similar type of cistern? And if so any recomm ...

Why join the Bunnings Workshop community?

Workshop is a friendly place to learn, get ideas and find inspiration for your home improvement projects