Hi Simon55. I actually ended up scrapping my original waterproof idea with mounting panels underneath the decking. The main reason being that decks ar ...
No worries, thanks. I’ll check back with the builder re the hebel.
The range hood manufacturer weren’t very helpful. They said to refer to the instal ...
Thanks, Jacob.
Yeah, I have the fixing guide but it doesn’t have anything specific to range hoods.
We have Hebel Power Panel for a double story hou ...
Hi @Nailbag The Colorbond Trays you use, where do you purchase these from and are they custom made to size?Our deck is 3000mm wide so I could flush th ...
Thanks for the insights, Jacob. Thanks for correcting my math - I’ll ensure there’s sufficient fall to avoid pooling. I had considered using tradition ...
Hi @Bubbles8712 the trays were custom bent on site by a roofing plumber running into again a custom gutter tray. The trays themselves are not fixed to ...
Hello @Bubbles8712
Let me tag @Nailbag to make them aware of your questions. The tape you are referring to is called CAgroup 50mm x 20m Bearer Prot ...
Hi @Bubbles8712,
If the air vent vents to another location other than the cavity, like the roof, it would allow some hot air to escape. However, you ...
Welcome to the Bunnings Workshop community @Bubbles8712. It's wonderful that you've joined us, and many thanks for your questions about barn door cons ...
Hi Simon55. I actually ended up scrapping my original waterproof idea with mounting panels underneath the decking. The main reason being that decks ar ...
No worries, thanks. I’ll check back with the builder re the hebel.
The range hood manufacturer weren’t very helpful. They said to refer to the instal ...
Hi Splinters. As a result of using the 30mm header board, we have about a 60mm gap between the wall and door so the door doesn’t do much to reduce sou ...
I used the 310 system with the 38mm screws (links below). It would have been quicker to have the more expensive Kreg system which allows you to make m ...
Success. We used five 14G x 85mm zenith screws to mount the 30mm thick timber header and then mounted the rail kit as per instructions and supplied ma ...
Project is coming along quite smoothly. After cutting the timber to size, I drilled pilot holes on each of the horizontal pieces using a Kreg pocket ...
We are FINALLY about to construct and install the barn doors. Slight change of plans re materials and design - we are now using 140mm X 12mm tongue an ...