Fell off the ladder (doing the job) so I have been quiet for a bit.
Glued with high strength water based liquid nails
Filled the gaps
Sanded and the ...
@MitchellMc @Noyade @Dave-1 @EricL
Thank you everybody for your input. Now the actual doing....
1. Get a scrap cut at 90 and hold it upright over the ...
Thanks for that @MitchellMc . It appears what you are saying is consistent with the notion of a scribe joint. However my spatial skills are considerab ...
Thank you for your persistence with with me Dave @Dave-1
I understand where your coming from now. I take it I need to trace the right hand side of th ...
Is this what you mean? Unfortunately you cant see the tips of the pencils and it is difficult to get the correct angle so the lead makes contact with ...
Thanks for all the responses - appreciated
Re @EricL suggestion. That 45 cut was the first thing I tried and this is the result
So I am not sure how ...
Hi there
I have had a pantry installed in my kitchen and as you can see from the photo, the job requires 90mm cove cornice installed around the bulkhe ...
Hi @MGusto,I'm so sorry to hear of your fall. I hope you are alright and nothing too serious came of it.Cornice is not an easy material to work with a ...
I got you, @Noyade and @MGusto!!Great minds, hey! I've been drawing it up. As best I can tell, even though it's a butt joint and not a mitre, it's sti ...
Afternoon @MGusto
Nooo The piece you have in your hand, bring it towards you so it can sit over the short piece fo cornice on the wall, then you draw ...
Hello @MGusto
You are halfway there my friend! Place the pencil set in parallel on the cornice on the left, using the cornice attached as a guide f ...
Hi @MGusto
Thanks for sharing your question about cutting your cornice. I propose trying this technique, cut your cornice at a 45-degree angle slan ...
Hi @MGusto
cutting both internal and external cornice cuts is very confusing even for plasterers if they aren't paying attention. Most use jigs and ...
Morning @MGusto
Ahh cornice the stuff that does my head in.... Tho if you like puzzles then you will have fun! Seriously getting it worked in your m ...
Fell off the ladder (doing the job) so I have been quiet for a bit.
Glued with high strength water based liquid nails
Filled the gaps
Sanded and the ...
@MitchellMc @Noyade @Dave-1 @EricL
Thank you everybody for your input. Now the actual doing....
1. Get a scrap cut at 90 and hold it upright over the ...
Thanks for that @MitchellMc . It appears what you are saying is consistent with the notion of a scribe joint. However my spatial skills are considerab ...
Thank you for your persistence with with me Dave @Dave-1
I understand where your coming from now. I take it I need to trace the right hand side of th ...
Is this what you mean? Unfortunately you cant see the tips of the pencils and it is difficult to get the correct angle so the lead makes contact with ...
Thanks for all the responses - appreciated
Re @EricL suggestion. That 45 cut was the first thing I tried and this is the result
So I am not sure how ...
Hi there
I have had a pantry installed in my kitchen and as you can see from the photo, the job requires 90mm cove cornice installed around the bulkhe ...
Hi thereI used this one https://www.bunnings.com.au/uni-pro-175mm-jumbo-deck-brush_p1662785 which did a good job of getting in between the the boards ...
