The Bunnings Workshop community can help with your home improvement projects.
Hi folks
We have recently purchased a porch swing and are planning to attach it to a pair of beams in alfresco. Porch swing contains two chains and the beams are 190x45 each. I can use eye screws but that would put load on a single beam. Is there a way to hang to both beams? Your help will be much appreciated.
Solved! See most helpful response
Hi @nvdshams
That beam is holding up a whole lot more roof rafters and tiles (with out seeing broarder roof pictures) So I should take an extra 300kg on occasions,
Maybe go past the beam into the ratfers sitting on top of beam so drilling into the beam dosnt weaken it. You can also add more rafter support inside the roof space,
Where is the second beam? Iwould want to try stabilise any sideways stress/movement from a swinging motion.
Thanks for the suggestion. Sorry for confusion but it is a single beam formed by sticking two 190x45 boards together. There is no second beam. Would it be a good idead then to attach a 90x90 or 100x100 post horizontally connected to both sides of wall and hang the swing from it?
Hi @nvdshams
The easy way out is attch the swing to that double beam But every time you drill it and cut it its a little weaker I am not saying it will collapse anytime soon .
So in the photo behind that beam above the white ceiling i am expecting to find 90x45mm roof raffters. If that is true.
I would like to place fix 50x 190mm between rafters for a screw in point for the eye bolts on the inside of the roof. One at each end and any swinging movment is supported That way the swing eye bolts also hidden behind behind the double beam. And the swing is reccessd back under cover a bit more.
Hi @nvdshams,
I'd recommend you fix a solid piece of preferably hardwood 90 x 45mm to the bottom of those beams. Screw through it into both of them along its length with several coach screws. You'll then be able to use a couple of eyebolts in the new timber.
Alternatively, and provided at least screws laminate the two beams together, you should be able to place the eyebolts in one of the beams, and the weight of the swing will be distributed to the other beam too.
Please let us know if you have any questions.
Mitchell
Hi @MitchellMc and @Jewelleryrescue
Thank you so much for your help. Turns out those two beams are hardwood and were laminated together. I hooked up to one of those.
Hi @nvdshams,
I am a little concerned after re-reading over this discussion that I didn't put a warning in regards to attaching swings onto existing structural timber beams. Structural beams are designed to hold the load they were installed for. In this case, it was the roof. The original builder did not intend to have up to 300kg of weight and the forces involved with a swing attached to the beam. There is a significant chance that these additional forces could exceed the capability of the timber.
I do apologise that I didn't include this warning, but I think it's important to point this out regardless of whether the installation has been completed or not. I suggest enlisting the services of either a builder or engineer to verify that the beams are capable of this additional load. This suggestion is what I would have made had I included the warning.
Mitchell
Hi @MitchellMc
Thanks for the warning, I will engage a builder to take care of it.
Kind regards,
Naveed
Workshop is a friendly place to learn, get ideas and find inspiration for your home improvement projects
We would love to help with your project.
Join the Bunnings Workshop community today to ask questions and get advice.