How to fix rubber seal underneath the window?

[SouthFieldSnoop]

During a recent DIY project, I noticed that the rubber seals on the exterior bottom of my windows aren’t properly sealed. There are visible gaps in the seals, and I’m looking for a way to fix this. I don’t think replacing the rubber seals is an option, as it seems like that would require removing the entire window.

I’m considering the following approach:

1. Use a foam filler to fill the large gaps under the seals.
2. Apply exterior silicone around the window frame for added sealing.

My main question is: What type of silicone would be best for this purpose? I’m also planning to seal a couple of other windows where I’ve noticed similar gaps. Also is it safe to seal around the window infills, since there appears to be a gap between the timber infills and the brick wall

Any insights or product recommendations would be greatly appreciated!

 

[EricL]

Hello @SouthFieldSnoop 

If the gap is very big then using self-expanding foam in that gap is what you need to use. However, in order to provide a good weather seal, I suggest using Selleys 290ml Grey Storm Waterproof Gutter And Roof Sealant. It delivers a waterproof seal on any almost material and can even be applied in the rain to stop leaks immediately. It’s ideal for sealing skylights, gutters, downpipes and windows, and can be painted over with water-based paint.

If you need further assistance, please let us know.

Eric

[Jewelleryrescue]

Hi @SouthFieldSnoop 

Some  good points you raise there in how these windows and frames arre assembled.

Your points

0,5 Yes those rubber seals are apart of the window and can not easily be replace plus they are barely scanning the brick gap any way. We will come back to this soon.

1 An expanding aerosol foam product will fill those large gaps under the seal or a lot of gap filler.  Read on we may not have to do that.

2 It will be hard to silicon that area and make it look nice but read on.

You read on so here we are:   I propose a flat black rubber strip cut to size and glued in place with clear storm silicon that will span across the old rubber and span out over the gap to the brick work with decent coverage of it all.

This will cover every thing and at the same time seal the gaps

If need be place the new strip out from the windowsill a couple of mm if the other brick work gaps bigger than the one in the photo.

Wipe the silicon messes off with a rag and turps.

Moroday 15 x 1.5mm x 5m Black Rectangle Rubber Roll I/N: 4000062 $12^.58

Selleys 290ml Clear Storm Waterproof Gutter And Roof Sealant Clear I/N: 1230165 $19^.99

 https://www.bunnings.com.au/selleys-290ml-clear-storm-waterproof-gutter-and-roof-sealant-clear_p1230...

[SouthFieldSnoop]

Hi @Jewelleryrescue 
I do like the idea of using a rubber seal to get a cleaner look, I found a similar product here with 38MM width, which would work in my case.
Does Selleys sealant work as an adhesive? If it does, how much contact area is required to ensure the rectangular rubber stays securely in place?