Share
Difficulty: Beginner
Repairing a water-damaged plasterboard ceiling involves fixing any peeling paint or cracks and removing water stains.
Once you have identified and addressed the source of the water damage, you can follow this simple step-by-step guide to make your ceiling look like new.
If you need any help with repairing your ceiling, please don't hesitate to ask. We're here to help.
Steps
Step 1
1/8The first step is to track down the source of the ceiling leak.
Possible sources could include a broken roof tile, inadequate roof flashing or even a leaking water pipe. It’s important to have these issues addressed before preforming any repairs to the ceiling.
After addressing any active water sources, allow the damaged area to dry thoroughly. This is especially important in ceiling cavities as mould can develop behind the plasterboard.
For significant leaks, open up the ceiling and use a fan or de-humidifier to dry the residual moisture.
Step 2
2/8Chip away any cracked paint or crumbling plaster using a putty knife. Clean up the area and remove any compromised material.
If there was a minor leak and the only damage was stained paint coating, then prime the area with a stain blocker and apply a fresh topcoat of paint.
Step 3
3/8Apply a small amount of plaster filler to the affected area using a putty knife.
Force the filler into any holes, cracks and depressions. Leave it to dry fully before proceeding. In warm weather, this may only take a couple of hours, but in cooler areas, it could take up to 24 hours.
Step 4
4/8Use 120-grit sandpaper and a sanding float or block to lightly sand back the filler until it is flush with the surrounding plasterboard.
Next, apply more filler over the entire damaged area using a putty knife. Do this sparingly.
Ensure this filler is only slightly proud of the surface. Wait for it to dry before sanding back flush with the surface using the 240-grit sandpaper.
Inspect for any areas you might have missed or any inconsistencies. Repeat this process until a uniform surface is achieved.
Step 5
5/8Apply self-adhesive reinforcement tape to areas where the plasterboard is cracked.
Next, apply filler over the tape before allowing the filler to dry completely. Sand the excess filler back with 120-grit sandpaper until the tape begins to show.
Then, apply a thinner coat of plaster over the area and extend it out into the surrounding ceiling.
Note it is not possible to disguise a crack that requires tape by simply plastering over the taped area. You must extend the plaster into the surrounding ceiling to taper it off and provide a transition.
Step 6
6/8Remove excess plaster using a sanding float and 120-grit sandpaper.
Once the area is smooth, switch to 240-grit sandpaper and finish. You might require another fine skim coat of plaster to remove any imperfections.
Step 7
7/8After the filler is completely dry, apply a stain blocking undercoat to the damaged area with your roller. It is important for the undercoat to have stain inhibiting properties as water stains tenaciously bleed through paint coatings.
Allow the undercoat to dry.
At this point, any imperfections in your plasterwork will become evident. Fix them by filling or sanding the areas and then applying another layer of undercoat.
Step 8
8/8Apply pre-paint mould treatment to the damaged area with a spray bottle or by wiping over with a cloth.
Next, apply two coats of your ceiling paint over the damaged portion.
In some instances, it might be necessary to paint the whole ceiling. If this is the case, treat the immediate area with pre-paint mould spray before proceeding.
Materials
Tools
- Stain inhibiting primer
- Ceiling paint
- Plaster filler
- Self-adhesive reinforcement tape.
- Putty knife
- 120-grit sandpaper
- 240-grit sandpaper
- Sanding float or block
- Paint roller and tray
- Spray bottle or cloth.
Images
You might also like
