Hi @JacobZ,
It looks like pre-drilling with a countersink has taken care of most of the cracking, but our carpenter has had a look and was frustrate ...
Hi everyone,
Thanks very much for your help on my last post. Our carpenter has fixed up a few of the worst areas, but we still have some concerns. T ...
Hi @EricL, Thanks very much for your suggestions. Replacing all of the cracked boards seems like the best option, although that's about 60 boards on o ...
Hi @Nailbag, Thanks very much for your advice. The installer has advised that they were drilling pilot holes on the ends, but not in the middle of the ...
Hi @wooshka, Thanks very much for your reply. Yes, we are a bit disappointed. From far the deck looks nice, but it's a bit of a mess up close, and the ...
Hi @David10,
If your carpenter is predrilling and countersinking the screws, regardless of how dry the timber is, they should not split unless the s ...
Afternoon @David10
In all the times I have used merbau decking it has split on my twice, and thats because I was going to close to the edge on purpos ...
Hi @David10
I showed these photos to a registered builder mate of mine and he confirmed the main issue is that the screws have been installed to cl ...
Good Morning @David10
Thats a pain to deal with
Going forward I would be replacing the boards ( I do have the same thoughts as @Nailbag as to remo ...
Morning @David10
The benefit of pilot holes as you may know is to both stop wood from splitting and provide a much more secure bond of the top mate ...
I wonder if the screws are too close to the edge? We've just done our deck and while we pre-drilled (hardwood joists) and pre-countersunk, we also kep ...
Hi @JacobZ,
It looks like pre-drilling with a countersink has taken care of most of the cracking, but our carpenter has had a look and was frustrate ...
Hi everyone,
Thanks very much for your help on my last post. Our carpenter has fixed up a few of the worst areas, but we still have some concerns. T ...
Hi @EricL, Thanks very much for your suggestions. Replacing all of the cracked boards seems like the best option, although that's about 60 boards on o ...
Hi @Nailbag, Thanks very much for your advice. The installer has advised that they were drilling pilot holes on the ends, but not in the middle of the ...
Hi @wooshka, Thanks very much for your reply. Yes, we are a bit disappointed. From far the deck looks nice, but it's a bit of a mess up close, and the ...
Hi Community,
We've just had our deck redone and we've noticed a lot of cracks in the merbau where the screws are. Our carpenter has completed about ...