Workshop
Ask a question
since September
2 weeks ago
Miczam
Growing in Experience
  • My latest posts
  • Posts I liked
  • My liked posts

User's latest posts

Miczam
Growing in Experience
1 reply
2 weeks ago

that is now 100% clear. So the overhang will be on the outside of the door. I hope it wont look too bad in appearance. Anyway we will go with this and ...

Miczam
Growing in Experience
3 replies
2 weeks ago

Thank you. any chance you can do a rough sketch please. I want to make sure I get it right.

Miczam
Growing in Experience
5 replies
3 weeks ago

Hi There, the hinges purchased for these 2 external heavy doors are based on your department following up with Hume Doors. If you refer to the photos ...

Miczam
Growing in Experience
a month ago

In respect to the heavy duty hinges (ones above in silver) i purchased as per Hume door recommendations which i received from you, i was in bunnings t ...

Miczam
Growing in Experience
1 reply
October

Hi Mitch, So i am 100% sure, would Bunnings be able to verify the specs for these T hinges (they do say heavy duty) that they will be able to handle 6 ...

Miczam
Growing in Experience
9 replies
October

Hi Bunnings experts, As you are aware i am making 2 barn doors for external use and they are very heavy around 55kilos each. So you have recommended ...

Miczam
Growing in Experience
1 reply
October

Hi There, further to my earlier messages, i went to bunnings today and found hinges Matt Black, see pictures attached. I spoke with staff at the store ...

Miczam
Growing in Experience
2 replies
October

Hi Mitchell, If the width is 100mm and depth 125mm then the depth of my door is 50mm, how will i be able to fix the hinge to the edge of the doors?ple ...

Posts user liked

Bunnings Team Member MitchellMc
Bunnings Team Member
2 replies
2 weeks ago

Hi @Miczam, It should look like the image below. Here's a helpful installation guide. Mitchell

Bunnings Team Member MitchellMc
Bunnings Team Member
4 replies
2 weeks ago

Hi @Miczam, The overhang would be on the hinge side. On the opposite side, they should be recessed back from the edge, approximately 5mm. Please l ...

Bunnings Team Member JacobZ
Bunnings Team Member
a month ago

Hi @Miczam, I am confident that these hinges when installed in the orientation I've mentioned above will be fine. Jacob

Bunnings Team Member MitchellMc
Bunnings Team Member
October

Hi @Miczam, Provided you follow @JacobZ's advice above and use at least four hinges, two at the top, one in the middle, and one at the bottom, you s ...

Bunnings Team Member MitchellMc
Bunnings Team Member
2 replies
October

Hi @Miczam, You could certainly try them. As per the previous recommendations, you'll need to use at least three or more per door. What those hinges ...

Bunnings Team Member MitchellMc
Bunnings Team Member
1 reply
October

It's quite hard to visualise with placing the hinge up against the door @Miczam. Perhaps the below diagram might assist. As you are creating a custo ...

User's liked posts

Miczam
Growing in Experience
1 reply
October

HI Jacob, thank you. I will run with your recommendation and will go for 4 hinges for safety. Appreciate your feedback on this matter.

Miczam's Bookmarks
No posts to display.
Contact Me
Online Status
Offline
Date Last Visited
2 weeks ago