Coffee thoughts, where the best ideas are conceived ... along with the ones in the shower. If only there was a way to combine the two ...
Thanks @No ...
Thanks @Noyade. I'd love to use this as a reason to purchase a pop-rivet gun set but unfortunately I now don't have access to three sides of the shed. ...
Yes! That's exactly what I was thinking of too!
The other option was using a twist-on wire connector but the heat shrink tubing sounds like a winner ...
Thanks @EricL , @Dave-1 and @Nailbag . I especially love the idea of adding those channels!
What are your thoughts on using something like these wal ...
Great, thank you. Will post an update once I receive the clothesline and have put it up.
On a related note, which screws are recommended to attach t ...
Hi @SyedAhmed
What about using heat shrink? For a few dollars you just cut short strips off the tube and place it over the screw. Then use a heat-g ...
Hi @SyedAhmed
The wall plugs you mentioned are for brick and concrete use and usually deform and split when being used. I don't recommend using the ...
Hi @SyedAhmed
I would suggest just replacing the ones exposed on the inside to a flat surface (see image) and not worry about the recessed ones. Ju ...
Good Evening @SyedAhmed
That is an interesting problem and mythinking is along the same way as yours.
My idea is similar to @EricL's but differant en ...
Hello @SyedAhmed
I propose using a Porta 19x19mm 1.8m Round Dowel Grandis to cover the sharp ends of the screws. I suggest cutting the dowel into 1 ...
Hello @SyedAhmed
I propose using Zenith 10G x 65mm Galvanised Countersunk Head Metal Screws. My best advice is to drill pilot holes on the timber p ...
Coffee thoughts, where the best ideas are conceived ... along with the ones in the shower. If only there was a way to combine the two ...
Thanks @No ...
Thanks @Noyade. I'd love to use this as a reason to purchase a pop-rivet gun set but unfortunately I now don't have access to three sides of the shed. ...
Yes! That's exactly what I was thinking of too!
The other option was using a twist-on wire connector but the heat shrink tubing sounds like a winner ...
Thanks @EricL , @Dave-1 and @Nailbag . I especially love the idea of adding those channels!
What are your thoughts on using something like these wal ...
