Thanks Eric. Went with your advice and got the scotchbrite pad for the drill instead of the grinder. Does a good job. Scratches up the timber a bit bu ...
Hey crew!
Any pro tips on how to remove paint from pine doors with slats? The paint's a bit thin and rough with lots of globs and other debris stuck i ...
Update: Silicone has done its job. Flange no longer moves forward and it's concealed the gap nicely. Could finish it with a nice bead around each but ...
Update:I've siliconed the flanges to the wall (to stop them spinning or moving forward) and placed some silicone in the gap. Masking tape wouldn't hol ...
Update.Bunnings service team got back to me letting me know that the flange extender for this model had been discontinued. Decision is to just silicon ...
With the rubber behind the flange will it provide enough adhesion between the tiles and the flange to prevent the flange from moving? I'm thinking yes ...
Hello @Aneil
Thank you for sharing your louvre door repainting project. I'm afraid you've covered most of the recommendations I was about to give re ...
Hello @Aneil
What an amazing transformation. Thank you very much for sharing those photos of your bathroom renovation. The tapware came out very nic ...
Hi @Aneil
Thank you so much for the update. I totally agree that you should take the gaffa tape off slowly to avoid damaging the seal. Most silicone ...
Hi @Aneil
If you put enough silicone on top of the rubber piece it will form a seal on top of it. However, it will not bond to the rubber surface if ...
Hi @Aneil I believe my colleague was possibly referring to the spindle locking nut. It is adjustable, but I'm afraid it might not help in your current ...
Thanks Eric. Went with your advice and got the scotchbrite pad for the drill instead of the grinder. Does a good job. Scratches up the timber a bit bu ...
Update: Silicone has done its job. Flange no longer moves forward and it's concealed the gap nicely. Could finish it with a nice bead around each but ...
Update.Bunnings service team got back to me letting me know that the flange extender for this model had been discontinued. Decision is to just silicon ...
With the rubber behind the flange will it provide enough adhesion between the tiles and the flange to prevent the flange from moving? I'm thinking yes ...
Thanks for all your help guys! I really do appreciate it! My only concern is that the flange isn't secure. It's held in place by an o-ring that provid ...
Hey Eric.Yeah. I got these stainless steel guys and the ID of the hole was too small to go over the nut on the ceramic disk extenders. Had to get a pe ...