Hello,
I know there has been some really helpful discussions on bearer deck post connections already (including this one that was really useful) but I ...
Hello,I was wondering whether anyone had advice on what tool to use and how to open the metal plumping pipe cap pictured to unclog the pipe? A while b ...
Thanks so much Eric - really appreciate this. Yeah will make sure to include adequate space so there is an air gap! Actually started to remove what I ...
Thanks Sudarsoe - really appreciate this. This is a great idea & will also make for some nice consistency with the deck I'm installing (which will hav ...
Thanks so much @MMF155 - really appreciate your thoughtful insights about ensuring both form & function (& will definitely take your thoughts on board ...
That should be fine, @Michael11. Though, if I understand correctly, to use a bolt or coach screw, you'd just countersink the head with a spade bit. St ...
Hi @Michael11
Just a friendly reminder that if you are planning on putting composite boards on your steps make sure to put in an air gap so that moi ...
@Michael11
Hi Mike.
Have you considered encasing it with wood? (Using composite decking products)
so, the idea is to rest it on the existing concrete ...
I'd suggest picking up a masonry bolster and a club hammer @Michael11.
Start at the edges where the concrete meets the brick. Place the bolster on t ...
Hi @Michael11,
To add to @EricL's response, I believe the priority here is to address the inadequate depth of the steps and any safety issues. I sug ...
Hello @Michael11
Thank you for sharing your question about your outdoor steps. Since the initial repair of your steps was not ideal, I suggest remov ...
Hi @Michael11 I used these they type of fasteners https://www.bunnings.com.au/ramset-3-16-x-50mm-countersunk-head-toggle-spring-4-pack_p2265630 to m ...
Hi @Michael11
The wall anchors that you have shown are for concrete or brick walls
I normally use these wall mates for plaster walls where there is n ...
Thanks Sudarsoe - really appreciate this. This is a great idea & will also make for some nice consistency with the deck I'm installing (which will hav ...
Thanks so much @MMF155 - really appreciate your thoughtful insights about ensuring both form & function (& will definitely take your thoughts on board ...