Hi Mitchell Thanks for the pointer on the timber door jamb. I had found it once but not been able to locate it a second time (just not able to get th ...
Thanks Mitchell I have read you suggestions in the Fixing rotten door moulding by @stelz discussion. I have used Builder's Bog previously to fix woo ...
I have discovered wood root at the bottom of the laundry door door jams. It affects the bottom 100-150mm on each side. I have both a solid laundry d ...
@JDE
Was asking as my Ryobi 18GA brad nailer struggles with Australian hardwoods? Yes, it will handle hardwood if it is clean and properly adjusted ...
Thanks MitchellI am putting potted plants in the plant stands and will be using foam blocks to keep the bottom of the tops above the water level.I wan ...
I am looking to build a couple of indoor plant stands for an enclosed veranda area that will hold ferns and other plants that like to be heavily water ...
As per your advise @JaneK , here it is Clean up the palettes lightly ( I had used Sander with 40 grit Sand paper ) .Once its clean you can see and dec ...
TimThe ryobi uses standard staples I ended up buying Ithink they were craft light ones from Bunnings. Sorry my wife has pinched it as she uses it when ...
Hi @tibz_timber,
You could use GRUNT 2m x 5m Black 200um Medium Impact Pro Builder's Film Handy Roll to create a waterproof section inside each stan ...
Welcome to the Workshop community @Diannelin. I'm happy to answer your question.
I would advise using the 420mm batts and strapping. Strapping them ...
TimDWe recently did this. Yes it definitely had an effect. Not as much as doing the ceiling. As Mitchell said watch some of the bunnings videos https: ...
Hi Mitchell Thanks for the pointer on the timber door jamb. I had found it once but not been able to locate it a second time (just not able to get th ...
@JDE
Was asking as my Ryobi 18GA brad nailer struggles with Australian hardwoods? Yes, it will handle hardwood if it is clean and properly adjusted ...
Thanks MitchellI am putting potted plants in the plant stands and will be using foam blocks to keep the bottom of the tops above the water level.I wan ...