The Bunnings Workshop community can help with your home improvement projects.
Difficulty: Beginner
Organise and decorate your bathroom or powder room with this streamlined shelf that not only looks attractive but also makes fantastic use of space.
Inspiration for this creation comes from the extremely popular Toilet roll holder shelf by Bunnings Workshop member @Rodney. Thanks again for sharing your wonderful project with us Rodney.
Start by cutting your 2.4m length of 110mm timber into four pieces at 600mm long using your handsaw or mitre saw. Each of these cuts will be at a 45-degree angle.
Lay your pieces out to check that the 45-degree cuts match up to form 90-degree corners. It is likely that there will be some gaps. You can dry clamp the pieces to get an idea of how close your cuts have been. Some slight sanding might be necessary to ensure minimal gaps.
Painter’s tape can be used to help form the corners. Lay a piece of tape down and place two of your timber pieces onto it so the edges line up correctly. Apply PVA glue to the inside of the corner. Bring the timbers together to complete the corner. Repeat this on the other three corners.
Once all the corners have been brought together, use a pull strap to hold everything securely. After the strap has been tightened, insert timber blocks under it to increase the tension. Additional clamps can also be used to ensure the corners are at a right angle.
Pre-drill three holes per corner with a 3mm drill bit. Counter sink the holes deep enough that the head of the screw will be below the surface of the timber. Drive in the screws.
Measure across a diagonal between two corners. Take this measurement and transfer it onto the 1.2m length of 90mm timber. Create a 90 degree on both ends of the timber by intersecting two 45-degree cuts. Apply glue to the inside of the corners you measured between and insert the timber.
Remove the tape and clamps and then apply putty over all the screws and any gaps from your 45-degree cuts. Wait for this to dry and then sand back. Apply a second skim coat and then repeat the sanding process.
Begin brushing you stain onto the timber. Use a rag or paper towel to wipe off excess.
Predrill holes with a 3mm drill bit to suit your mounting hangers. Install the hangers with timber screws.
Congratulations. You have now completed your toilet roll holder shelf. Expect plenty of admirers of your handiwork.
You must be a registered Workshop community member to comment. Please join Workshop or sign in to join in the discussion.
Workshop is a friendly place to learn, get ideas and find inspiration for your home improvement projects
We would love to help with your project.
Join the Bunnings Workshop community today to ask questions and get advice.