I have recently laid laminate floating floor. I removed vinyl edge cap between carpet to carpet and carpet to tile. I noticed the edge cap didn’t push ...
I am owner occupier of a 2 bedroom flat upstairs with a balcony within a block of flats total of 8 flats.
I would like to have security cameras and lo ...
Living in a duplex and shared a common brick wall with a noisy neighbor who like late night music. Saw these acoustic slat and thinking about installi ...
Hi,
So we moved into a new property as renters about 7 years ago, we have recently vacated. I have patched up a wall where we had a shelf and painte ...
Hi,
I will be building a studio in our backyard which will have a flat roof (5 degree pitch). And I was looking at getting timber ordered for it and ...
My aim is to use Murabond cement based paint (with added sand) on my block walls to give them some texture. And cover the mortar gaps. First i need to ...
I have an Ikonic digital entry lock installed on an external gate.
Recently the latch has been sticking and not returning fully to enable the gate to ...
I am looking to replace the cladding on my house from 1985. I have had it confirmed that there is no asbestos. Reviewing the James Hardie Specificatio ...
Hey there,
The situation is this: my partner and I have begun painting our apartment walls which includes the door frames. The door frames are made ...
Hi I’m looking at starting a low level timber deck in a recently built house but just need some advice if I’m on the right track or someone to steer m ...
Hi folks!
The weekend DIY renovation of our 80s fixer-upper is now three months in and still very much a building site but we’re almost at the poin ...
Hi, I have just laid laminate flooring and need a solution to add a trim from where the flooring meets tiles. They are not at the same level. I have l ...
My wife and I started this project and it took us 2 weeks to finish (due to commitment towards our full time job and of course kid too). We both are v ...
I had a lockable window winder that needed to be replaced. The issue was that it was stuck in the closed position. Which meant I couldn't unwind the c ...